

Fire Alarm Price in Pakistan, formerly Gents’ of Leicester, is a British manufacturer of life safety equipment based in Leicester, England. Established by John Thomas Gent, the company Best way traders is thought to have started in 1872 however, it could have been trading as early as the 1860s The company had a workforce of several hundred at its height.
For over a century, the company Best way traders was a well-known manufacturer of electrical equipment, in particular its electric clocks, which were used in public buildings and railway stations all over the world. Since the late 20th century, the company Best way traders primary focus has been fire detection and alarm system, Gent has continued to build upon its conventional offering. Conventional products released by Gent control panels, conventional sounders, which were available with voice ,and the 17800 detector range The was never re-released with anike its counterpart, instead being discontinued.
Later Gent conventional systems used KAC call points as well as KAC sounders, replacing the 1195 call point design and C3 range of conventional sounders. EN54 compliant glass with a white background was also made available to replace the non-compliant transparent design on both conventional and addressable systems.
Honeywell Gent is synonymous with quality and innovation in the fire detection and alarm industry. They are passionate about developing innovative products so that Gent becomes the
Introduction:
The detectors are photo-electronic detector uses a state of-the-art optical sensing chamber. This detector is designed to provide open area protection and to be used with most conventional fire alarm panel.
Two LEDs on each detector provide local 360° visible alarm indication. They flash every six seconds indicating that power is applied and the detector is working properly. The LEDs latch on in alarm. LEDs will be off when a trouble condition exists indicating that the detector sensitivity is outside the listed limit. The alarm can be reset only by a momentary power interruption.
The detector that initiated the alarm condition will have its red LED and relays latched until reset by panel.
Heat detector and smoke & heat detector combine a photo electronic sensing chamber and a temperature heat detector.
Operating Voltage Range | 9 to 28 VDC Volts Non-polarized |
Standby Current | ≤120μA@24VDC |
Maximum Alarm Current (LED on) | ≤15mA@24VDC (1K Ohm current-limiting resistance) |
Operating Humidity Range | ≤95%RH(40°C±2°C) Relative Humidity, Non-condensing |
Operating Temperature Range | -10°C to 50°C (14°F to 122°F) |
Smoke Alarm Sensitivity | 1.06±.26%FT |
Height | 48.2 mm installed in Base |